ENMA EDUCATION 2008 and
ENMA ELECTRIC 2008
July 7-9, 2008
Instructions for Abstracts
Instructions for ABSTRACTS for enma2008
Alfred Pitt1, María Sánchez1, John F. Siebert2
pitt@yahoo.com msanchez@ehu.net jfs@unibilbo.edu
|
1Department of Applied Mathematics |
2Department of Electric Engineering |
|
|
Technological School |
|
University of the Basque Country |
|
|
Alda. Urkijo, s/n – 48013 |
|
|
|
|
Abstract. The abstract should summarize the contents of the paper and should contain at least 70 and at most 400 words. Paper size: A4. Margins: top, 2.5 cm; bottom, 2.5 cm; left, 3 cm; right, 3 cm.
The text of the abstract will be justified, except title, name of authors with emails and addresses, which will be centred.
Paper title should be typed at 2.5 cm from the top of the page in CAPITALS and bold and must not be underlined; it will be centred and 16 point font size. After title, there will be one blank line (12 point size), and after that, name of the authors (12 point size). Decorations, logos, degrees and professional qualifications should not be included.
Next, emails of all of the authors will type without hiperlinks and not underlined. Use 11 point font size for emails. Type emails in the same order than authors, separated with one tabulator, centred.
Leave one blank line (11 point size) and then type centred department, faculty, university or technological centre, postal address, and city and country. If there are authors with different data, use table with 2 or more columns (table and its cells without borders).
Two blank lines 10 point size after addresses, write abstract.
Abstract should be set in 10 point font size and should be inset 1.0 cm from the right and left margins. Justified. There should be 2 blank lines (10 point font size) before and after the abstract..
